Cable and traction elevators in Tampa

Who this is for

These drives suit new construction and large remodels where a shaft can be planned from the start. Fixr notes that cable-driven elevators tend to cost less than hydraulic units in a new home, about $25,000 compared with $40,000.

Do cable and traction elevators in Tampa need a permit?

Inside the City of Tampa, the Construction Services Division provides all building permit and inspection services, so that is where an elevator for your home is permitted; in St. Petersburg, Clearwater and unincorporated Pinellas, the local building department or Pinellas County Building and Development handles it. The state elevator bureau does not regulate elevators serving one family residence.

Neither Hillsborough nor Pinellas is a contracted elevator jurisdiction, so an elevator serving shared condo areas is permitted and inspected by the state bureau directly, at $325 to install a regulated conveyance.[6][7][8][3]

Tampa home values and cable and traction elevators

The median owner-occupied home is valued at about $494,400 in the City of Tampa and $398,400 in Pinellas. IRS Publication 502 says medical lifts usually do not add value, but elevators generally do, which affects any medical expense deduction.

About 56 percent of Hillsborough County homes are detached houses, the highest share of the areas we serve, and many are single-storey. In those homes the need is often a few entry steps, which is porch lift or short stair lift territory, while two-storey homes in newer suburbs suit an elevator or stair lift.

About 59 percent of Pinellas County homes were built before 1980, and the median home dates from 1976; in the City of Tampa the figure is 42 percent. Bungalows in Seminole Heights and Hyde Park and 1960s block ranches in Pinellas often have raised floors with front steps, narrow doorways and older wiring.[2][9][4][10]

Help paying for a cable or traction elevator in Hillsborough

For Medicaid long-term care, Hillsborough is in Region D and Pinellas in Region C. Screening starts with Senior Connection Center on (813) 740-3888 (toll free (800) 336-2226) in Hillsborough, or the Area Agency on Aging of Pasco-Pinellas on (727) 570-9696. Elevators are not named among covered adaptations. Eligible veterans can apply for the VA's Specially Adapted Housing grant, up to $126,526 in fiscal year 2026; James A. Haley Veterans' Hospital on Bruce B. Downs Boulevard is the local VA hospital.[11][12][13][14][15][5]

What is different about a home lift in Tampa Bay?

Tampa Bay is outside the High Velocity Hurricane Zone, which covers only Miami-Dade and Broward, so outdoor lifts follow the standard Florida wind rules. Storm surge is the bigger planning point: Hurricane Helene brought 5 to 7 feet of inundation within Tampa Bay in September 2024, and the St. Petersburg tide gauge set a record of 6.31 feet above high tide. FEMA expects a float switch on any elevator that could descend below the base flood elevation.[16][17][18]

Permits in Tampa

• City of Tampa Construction Services Division: Provides all building permit and inspection services for property development in the City of Tampa, including the building and electrical permits for a home lift.
• Pinellas County Building and Development: Building permits in unincorporated Pinellas County; St. Petersburg, Clearwater and other cities run their own building departments.
• Florida DBPR Bureau of Elevator Safety: Regulates covered elevators directly in Hillsborough and Pinellas, such as lifts in shared condo areas ($325 to install a regulated conveyance). Lifts serving only one family residence are not regulated by the bureau.

What is the difference between cable, chain and traction drives?

Cable-drum elevators wind a cable onto a drum. Chain-driven models use a chain, which Fixr describes as stronger and longer-lasting but loud. Traction elevators use a motor and steel cables or belts over a sheave, and gearless versions keep the machine compact. FEMA notes that traction elevators lift the cab using steel cables and a traction motor.[1][18]

Machine room or machine-room-less?

An MRL unit fits the machine inside the shaft and needs fewer working parts. Fixr puts the average MRL cost at $45,000, against at least $60,000 for a machine room model. In a home, losing the machine room often frees a closet.[1]

Frequently asked questions